Stack Pad Pipefitter from System One
Houston, TX 77041
About the Job
Stack Pad Pipefitter
Houston, TX 77041
System One is currently seeking a Stack Pad Pipefitter on a 6 month contract position located in Houston, TX.
Stack Pad Pipefitter Responsibilities:
Stack Pad Pipefitter Requirements:
Duration: 6 months
Location: Houston, TX 77041
Pay Rate: $34.28-38.00/hr
SCHEDULE: DAY SHIFT - 5:00AM START TIME, STOP TIME RANGES FROM 1:30PM, 3:30PM, 5:30PM BASED ON WORKLOAD
SHIFT DIFFERENTIAL OF $2PH WILL BE APPLIED IF THEY MOVE TO THE NIGHT SHIFT.
Houston, TX 77041
System One is currently seeking a Stack Pad Pipefitter on a 6 month contract position located in Houston, TX.
Stack Pad Pipefitter Responsibilities:
- Pull, push, or pry steel components into approximate position while member is supported by hoisting device.
- Force components in to final position, using crowbars, jacks and hand tools.
- Verify vertical and horizontal alignment of components using cutting torch.
- Cut steel components to make alterations using cutting torch.
- May repair products by dismantling, straightening, reshaping, and reassembling parts using cutting torch and tools.
- Lay out, fabricate, assemble and install piping and piping systems.
- Plan and coordinate daily work with limited supervision.
- Perform other work related tasks as assigned.
- Comply with all Company and HSE policies and procedures.
- Ability to follow leads direction with little supervision.
- Plan layout and installation in accordance with instruction or work requirement schematics.
- Work at elevated heights
- Operate man lift, scissor lift, and overhead crane.
- Understand common practices for instrument fitter.
- Work in fast pace, always changing environment.
Stack Pad Pipefitter Requirements:
- High School Diploma or GED.
- 3 or more years related experience.
- Read and interpret assemble/hydraulic drawings.
- Able to measure, cut, bend and fit-up various sizes of stainless-steel piping 1", 1-1/2", and 2"
- Able to layout full scale drawing of piping systems.
- Able to read and interpret assembly and hydraulic drawings.
- Able to maintain and operate hydraulic tabletop bender.
- Able to layout pipe runs and pipe support brackets in accordance with company procedures.
- Able to layout, position, align, and secure sub-assemblies using a level, straight edges, combination squares, plum bobs, and measuring tape.
- Will be working in a non-climate control environment.
Duration: 6 months
Location: Houston, TX 77041
Pay Rate: $34.28-38.00/hr
SCHEDULE: DAY SHIFT - 5:00AM START TIME, STOP TIME RANGES FROM 1:30PM, 3:30PM, 5:30PM BASED ON WORKLOAD
SHIFT DIFFERENTIAL OF $2PH WILL BE APPLIED IF THEY MOVE TO THE NIGHT SHIFT.