Instrumentation Engineer at GlobalPundits
Aiken, SC 29801
About the Job
DUTIES:
Provide design engineering staff augmentation support to CLIENT. Primary responsibilities include engineering analysis, walkdowns, design development and generation of design output documents including but not limited to: P&IDs; Control Logics; Loop Diagrams; Instrument Indices; Setpoint Lists;
Instrument and Control Valve Specifications; DCS and PLC Design; Instrument Location and Installation Design; Panel Layouts; and Vendor Document Review.
Engineering services shall be provided using CLIENT processes and procedures. Programmatic guidance will be provided by CLIENT.
REQUIRED QUALIFICATIONS: EDUCATION & EXPERIENCE:
Ph.D. degree in applicable science or engineering discipline and 5+ years' experience. OR A MS with 8+ years' experience. OR A BS with 10+ years' experience or more.
Position specific:
BS Degree in one of the following disciplines: Mechanical Engineering, Electrical Engineering, Chemical Engineering, Nuclear Engineering, I&C Engineering, or current registration as a Professional Engineer in one of the above disciplines.
Experience/Skills:
Candidate must demonstrate ten (10) years of direct I&C design experience (within the last 15 years) in the nuclear or process chemical industry.
Candidate must demonstrate design experience with process control instrumentation, PLCs and distributed control systems. Proficiency in using MicroStation 2D Computer Aided Drafting and Design (CADD) software is required. Candidate must be able to perform weekly field walk downs of the job site for the engineering work being performed.
These walk downs may involve construction sites with uneven surfaces and work in progress, walking for distances of over half a mile, climbing of ladders to access remote areas, dressing out in protective clothing and environments where a respirator is required.
Provide design engineering staff augmentation support to CLIENT. Primary responsibilities include engineering analysis, walkdowns, design development and generation of design output documents including but not limited to: P&IDs; Control Logics; Loop Diagrams; Instrument Indices; Setpoint Lists;
Instrument and Control Valve Specifications; DCS and PLC Design; Instrument Location and Installation Design; Panel Layouts; and Vendor Document Review.
Engineering services shall be provided using CLIENT processes and procedures. Programmatic guidance will be provided by CLIENT.
REQUIRED QUALIFICATIONS: EDUCATION & EXPERIENCE:
Ph.D. degree in applicable science or engineering discipline and 5+ years' experience. OR A MS with 8+ years' experience. OR A BS with 10+ years' experience or more.
Position specific:
BS Degree in one of the following disciplines: Mechanical Engineering, Electrical Engineering, Chemical Engineering, Nuclear Engineering, I&C Engineering, or current registration as a Professional Engineer in one of the above disciplines.
Experience/Skills:
Candidate must demonstrate ten (10) years of direct I&C design experience (within the last 15 years) in the nuclear or process chemical industry.
Candidate must demonstrate design experience with process control instrumentation, PLCs and distributed control systems. Proficiency in using MicroStation 2D Computer Aided Drafting and Design (CADD) software is required. Candidate must be able to perform weekly field walk downs of the job site for the engineering work being performed.
These walk downs may involve construction sites with uneven surfaces and work in progress, walking for distances of over half a mile, climbing of ladders to access remote areas, dressing out in protective clothing and environments where a respirator is required.