Boxer - Sihl, Inc.

Job Title:  Boxer

Summary of Position:

A Boxer’s function is to package finished paper product into boxes and shipping containers. It is analogous

to assembly line work in that the same operation is repeated continuously the entire day. Product will come

down the conveyor at the rate of 2 to 6 rolls every 20 to 35 seconds. This is a fast-paced environment.

Duties & Responsibilities:

Initial daily responsibility -

Check work order to determine which bags, caps boxes and labels will be needed for the day,

1. Print labels for the product.

2. Bag and Box product.

a. The finished roll gets a cap in one end of the core, the bag is slid over the roll and the other end

is tucked in and capped.

b. The corresponding label is applied level and smooth, 2” from the top for Dietzgen product and

approximately1/3ed to halfway down for Canon product.

c. Finished roll is inserted into box and flaps are folded and glued. You will be required to plug in

glue guns and get supply of glue sticks as needed.

d. The corresponding label is applied to the outside of the box.

3. Palletizing

a. Pallets are removed from a stack approximately 4 feet high. Pallets weigh 25lbs.

b. Once placed on the floor a corrugated pad is set in place on the top of the pallet before boxes

are stacked.

c. Boxes are placed on the pallet in specific stacking configurations and must be followed.

d. Boxed roll product may weigh up to 50# per box and stacked up to 48” high.

4. Cargo’s

a. Pallets are removed from a stack approximately 4 feet high.

b. A cargo box is made up from two parts and placed on pallet squarely.

c. The finished roll does not get a cap; the bag is slid over the roll and then tucked in on the other

end.

d. The corresponding label is applied level and smooth 2” from the top for Dietzgen product and

approximately 1/3ed to halfway down for Canon product.

e. The roll is then placed in a cargo box standing vertically.

f. When the box is full, all rolls are counted to verify that the quantity is correct.

g. The flaps are folded in and taped shut

h. The corresponding label is applied to opposite sides on the outside of the box.

5. Daily Cleaning

a. Conveyors

b. Table’s

c. Floor Sweeping

d. Breakdown empty boxes and put in recycle box.

e. Clear floor of finished product.

f. Put raw materials back in bin locations.

g. Keep work area neat and clean.

h. Empty trash cans and replace with new trash bags.

i. Clean up after yourself in break room. (Spill’s, tables, refrigerator, microwave, etc.)

6. Quality

a. Labeling must be correct format and matched to the product.

b. Labels must be applied level, and in the proper location.

c. Rough handling of rolls will cause damage and is not acceptable.

d. Boxes must be kept clean and free of tears.

e. Gluing must be done correctly or box will come open later.

f. Boxes must never have “trash” inside.

Requirements

1. Must be able to stand in one place for long periods of time.

2. Must be able to lift 50 pounds from ground to shoulders repetitively.

3. Must be able to read and comprehend labels and work orders in English.

4. Must be able to work in non-climate-controlled building which may be quite cold in the winter and close

to 100 degrees in the summer.

5. Must be able to do repetitive motions the entire shift.

6. Neatness and organizational skills are required.

7. Hearing protection is required when on the production floor (Tampa Only).

8. Must be able to operate a manual pallet jack.